MKU PA 23CM-1000W CU, Leistungsverstärker
MKU PA 23CM-1000W CU, Leistungsverstärker MKU PA 23CM-1000W CU, Blockdiagramm MKU PA 23CM-1000W CU, Anwendung

MKU PA 23CM-1000W CU, Power Amplifier

1280 ... 1300 MHz • 1000 W
Linear High Power Amplifier for the Amateur Radio Band 23 cm


High power, high efficiency and best linearity are achieved by our high power amplifier for the 23 cm amateur radio band. In comparison to tube power amplifiers, the used LDMOS transistors operate with a supply voltage of only +50 V DC. High voltage transformers, waiting for tube warm-up and retuning of the tube are the past! The amplifier can be mounted near the antenna to avoid power loss caused by long coaxial cable.
Safe operation is guaranteed by the internal overheat protection. The built-in sequencer can be used to control other devices like preamplifiers or coaxial relays. An output power of 2 kW is achieved by combining two MKU PA 23CM-1000W CU amplifiers. This is ideal for EME (earth-moon-earth operation)!
net: 2.268,07
2.630,96
incl. 16% Vat. plus shipping
Lead time on request
Frequency range1280..1300 MHz
Input power20 ... 30 W
Maximum input power30 W
Saturation power1000 W
Gain (small signal)typ. 17 dB
Harmonic rejection typ. 37 dB @ 1000 W
ON voltageswitched to ground
Supply voltage+50 V DC
Quiescent currenttyp. 1 A
Current consumptionmax. 40 A
Operating case temp. range-20 ... +65 °C
VSWR of loadmax. 1.8 : 1
Input connector / impedanceSMA-female / 50 ohms
Output connector / impedance7/16-female, 50 ohms
Casemilled copper, silver- / nickel-plated
Dimensions (mm)190 x 152 x 38.5
Weight4850 g (typ.)
  • Over temperature protection
  • Built-in sequence controller
  • Reverse polarity protection
  • Output for "RF-ON" LED
  • Milled copper case, silver plated
  • Amateur radio: EME Contest
Please notice the following:
  • Attention: The recommended fans need a supply voltage of 24 ... 28 V DC.
  • The technical specifications refer to room temperature.
  • The power amplifier doesn’t contain any coaxial relays.
  • The recommended combination of heat sink and fan(s) is only specified for an ambient temperature of 25 °C.
  • Further information about dimensioning of heat sinks is available on our FAQ site.
  • We explicit point out that the recommended combination of heat sink and fan is not dimensioned for constant full output power of the power amplifier. The duty-cycle should not exceed 50% (1min transmitting / 1min receiving (WSJT)).
Our power amplifiers of the MKU-series are exclusively intended for amateur radio applications and will only be sold to radio amateurs with a licence. These products are specified for amateur radio requirements and are not designed for industrial applications. Please notice our list of industrial products or ask for a special version

Accessories

References